Contents
Is hydrophone a microphone?
A hydrophone (Ancient Greek: ὕδωρ + φωνή, lit. ‘water + sound’) is a microphone designed to be used underwater for recording or listening to underwater sound. A hydrophone can detect airborne sounds, but will be insensitive because it is designed to match the acoustic impedance of water, a denser fluid than air.
Is condenser mic good for calls?
Condenser mics are the best microphones for Zoom calls because they are extremely sensitive, so they can easily capture your voice at your desk or in a huddle room. Using a USB mic with Zoom also means your computer will do the setup for you since USB devices are Plug’n’Play.
How deep can a hydrophone go?
Cetacean Research Hydrophone Specifications Comparisons
| Model Number | C57 / C57X | C57RS / C57XRS |
|---|---|---|
| Maximum Operating Depth [m] | 370 | 920 |
| Operating Temperature Range [°C] | -40 to 60 | -40 to 60 |
| Output Impedance [Ω] | 10 | 10 |
| Dimensions [mm] | 116L x 25dia. | 116L x 25dia. |
What kind of preamp for contact mics?
The contact mics are similar to the DIY method described above but the “buffered” options include a phantom-powered preamp. A respected UK field-recordist and sound artist who also makes contact mics and hydrophones. Similar to the DIY method described above, but sealed and rugged.
Can a hydrophone be connected to a mixer?
It’s a very good idea to connect your hydrophone to a mixer and check it actually works before you close the case. Before closing the unit, I covered the pre-amp circuit with a lot of hot glue to seal it off from any stray water. Completed steel-can hydrophone.
What do you use to seal a hydrophone?
Mic lead glued in position. I coated the mic cable with hot glue and pulled it through the chimney, then splurged lots more glue where the wires enter the can. This is the most likely place water will try to enter the capsule, so make sure you seal it completely using ridiculous amounts of hot glue.
What do you need to make a hydrophone?
Completed steel-can hydrophone. My girlfriend bravely held the two halves of the case closed as I carefully soldered around the seam. Again, I used a steel brush to clean the surfaces before soldering. It was actually quite easy to do, and I like the quasi-welded appearance.