Is the RepRap discount full graphics smart controller garbled?

Is the RepRap discount full graphics smart controller garbled?

I have downloaded 2.0 bugfix ,my display is an Reprap Discount Full Graphics Smart Controller Display . Problem with the display is that is garbled after flashing the firmware. That problem did I also have with version 1.9 and that is solved by the following instruction.

Can You Define your own graphics smart controller?

I searched in config.h and I didn’t find such an comment I could change but I went back into (ultralcd_st7920_u8glib_rrd.h)tab And there is 3 lines where it says you can define your own.

How to fix full graphics smart controller display garble?

That problem did I also have with version 1.9 and that is solved by the following instruction. U8GLIB_ST7920_128X64_RRD u8g (0); // Number of stripes can be adjusted in ultralcd_st7920_u8glib_rrd.h with PAGE_HEIGHT U8GLIB_ST7920_128X64_1X u8g (23,17,16); // Number of stripes can be adjusted in ultralcd_st7920_u8glib_rrd.h with PAGE_HEIGHT

Why is my reprapdiscount graphic controller not working?

After flashing with the u8glib example – exmaple is working properly. And again – after flashing back to Marlin – LCD is also working properly with Marlin, until power is disconnected.

Where is the reset button on the RepRap smart controller?

Looking at the bottom face of the display card, with the ribbon cables going away from you (so the encoder, buzzer, and reset switch are to your right), the left socket is #1, and the right socket is #2. Change line 1532 to #define REPRAP_DISCOUNT_SMART_CONTROLLER (just remove the // at the beginning)

How to define sdsupport on reprapdiscount smart controller?

Change line 1429 to #define SDSUPPORT (just remove the // at the beginning) Upload the firmware, power off the Arduino, connect the panel, reapply power, and everything should work. Settings for RAMPS1.4 in “Configuration.h” search for “ULTIPANEL” and activate the define (remove the leading “//”)

Can a smart controller be connected to a ramps board?

Smart Controller. Based on bkubicek idea, we realized this smart controller. This Smart Controller contains a SD-Card reader, a rotary encoder and a 20 Character x 4 Line LCD display. You can easy connect it to your Ramps board using the “smart adapter” included.