Useful tips for everyday
What is updating your firmware? A firmware update will upgrade your device with advanced operational instructions without needing any upgradation in the hardware. A firmware…
How do you fix adhesion layer in 3D printing? 3D Print Layer Separation: 8 Tips to Avoid Delamination Sticking Together. Tip #1: Clean the Hot…
Do PEI sheets wear out? A touch too much. No matter how careful you are with handling the PEI, adhesion will eventually diminish. It’s surprising…
How do I smooth SLA print? The best way to sand SLA parts is to start with a low grit sandpaper, and slowly move to…
How do you cut a 2×2 diagonally? Start the saw and feed the plywood and 2-by-2 through the blade while keeping the edge of the…
What are knockdown fittings? Knock-down fittings are those that can be put together easily, normally using only a screw driver, a drill, a mallet/hammer and…
Why are contact names not showing on messages? If you find iMessage showing numbers, not name OR some of your contacts (possibly all) are missing…
Why does my sound stop working? Speakers get dirty or clogged, so a bit of cleaning could make sounds clear again. Before you clean the…
What happens if there is no contract? Starting work without a signed contract means that your position isn’t clear, or even worse –it’s weak. Along…
What levels should my mix be? I recommend mixing at -23 dB LUFS, or having your peaks be between -18dB and -3dB. This will allow…