Useful tips for everyday
What is the difference between flip-flop? The state of flip-flop changes at active state of clock pulses and remains unaffected when the clock pulse is…
Do vias need thermal relief? Vias that are not intended for use as pads for through-hole components should not include thermal relief pads. In fact,…
Where are the electrical grids? North America is comprised of two major and three minor alternating current (AC) power grids or “interconnections .” The Western…
What do you need to know about USB 3.0? An overview of the USB 3.0 architecture, covering the USB Host, USB Device (s) and USB…
Is it possible to drive a Peltier from PWM? CONCLUSION1: Current/Voltage load curve is reasonably linear, both driving from current or voltage source will do…
What is negative resistance in a circuit? In electronics, negative resistance (NR) is a property of some electrical circuits and devices in which an increase…
What are the components used in audio amplifier circuit? Components Required LM386 Audio Amplifier IC. 1000 µF Capacitor. 100 µF Capacitor. 10 µF Capacitor. 0.05…
How is a J-K flip-flop made to toggle? How is a J-K flip-flop made to toggle? Explanation: When j=k=1 then the race condition is occurs…
What is CC1 and CC2 in USB-C? For the USB Type-C solution, two pins on the connector, CC1 and CC2, are used to establish and…
What is g range in accelerometer? Measurement Range: The level of acceleration supported by the sensor’s output signal specifications, typically specified in ±g. This is…