Useful tips for everyday
What is difference between UART and RS485? RS485 or ANSI/TIA/EIA-485 designs use the same basic UART but with a different line driver IC. The line…
Can data augmentation lead to overfitting? While data augmentation prevents the model from overfitting, some augmentation combinations can actually lead to underfitting. In this blog…
How do you find upper confidence bound? You can find the upper and lower bounds of the confidence interval by adding and subtracting the margin…
What is Inception-v3 transfer learning? For transfer learning, the Inception-v3 architecture with pre-trained weights was used. Some initial layers were frozen and training was done…
What is the difference between breadth first search and best first search? Best-first search is informed whereas Breadth-first search is uninformed, as in one has…
Why does PETG print stringy? PETG is especially notorious for stringing because it requires a relatively high temperature to ensure good flow. This increased temperature…
How can I make my 3D prints thinner stronger? To improve the strength of FDM 3D prints: reduce cooling, increase extrusion width, use rectilinear infill,…
What infill type should I use? Standard 3D Prints For 3D prints subjected to low stress, such as the above filament guide, a medium strength…
Why is my stepper motor getting hot? Stepper motors do get hot. This is because the drive is supplying the motor with full current the…
Does PLA get brittle after printing? For a start, PLA, which stands for poly-lactic acid, is known to be relatively brittle. The property means that…