Should breadboard ends be glued?
For some methods, such as screws or nails, gluing the joint is probably not a good choice because you end up with a cross-grain glue joint. With dowels, glue is a necessity but you may decide only to glue the center or one side of the joint to allow for some movement.
How do breadboard ends work?
The breadboard ends are essentially rails that are mortised to accept tenons on the ends of the panel. They serve the same basic purpose as cleats screwed to the inside face of solid wood panels on rustic furniture, except that breadboard end joints are a lot more elegant and forgiving of wood movement.
How are the holes in a breadboard connected?
Most breadboards have holes which are organized in rows of five. The holes in each row are connected electrically. That is, if you insert terminals of electrical components in two holes in the same row, you have “connected” those two terminals to one another. The holes in different rows are isolated electrically.
How are the ends of a breadboard glued together?
Breadboard ends are typically joined to the panel by a tongue and groove joint. When it comes to cracking the joint isn’t the problem. Cracking happens if the ends aren’t properly glued to the panel. It’s all about judicious use of the glue, and knowing how to glue wood together.
How big should the ends of a bread board panel be?
Here’s how to plan a panel with bread-board ends. When you figure the overall finished length of the panel, take the breadboard ends into account. The breadboard ends are usually 2″ to 3″ wide, but you can make them wider or narrower for larger or smaller panels, if you wish.
What’s the best way to build a table with breadboard?
Discover five cross-grain construction strategies to help keep your tabletops and chest lids flat. Cross-grain construction tends to freak out most beginning woodworkers, but it’s a viable construction method in many cases. Wide tables and chest lids often employ breadboard ends to keep things flat, as well as cover end grain.
What’s the best way to keep a breadboard from cupping?
In the end, the best way to keep the primary board from cupping is to capture it in the breadboard end as much as possible. This narrows your joinery choices to sliding dovetails, tongue-and-groove joints, loose tenons or true mortise-and-tenons.