Should you use the disc or belt sander when sanding pine?

Should you use the disc or belt sander when sanding pine?

-In order to refinish your pine floor, you need to attach the 80-grit sandpaper to your belt sander. -To finish the area, you should turn around your belt sander. Go on with the rest of the floor until you are done. All the areas along the walls and corners should be sanded by use of the hand disc sander.

What precautions should be taken when using a disk belt sander?

What should you do to work safely with belt sanders?

1. Wear safety glasses or goggles, or a face shield (with safety glasses or goggles).
2. Wear a dust respirator for dusty operations.
3. Make sure the sander is switched “OFF” before connecting the power supply.

What is the fine for sanding pine?

Soft woods such as pine and alder: start with #120 and finish with no finer than #220 (for water base stains) and 180 grit for oil base stains. Hardwoods such as maple and oak: start with #120 and finish-sand no finer than #180 (for water base stains) and #150 grit for oil base stains.

How long does a sanding belt last?

The abrasives we sell at Pete’s have very distinct lifespans; drum sander belts should last between 250 and 300 square feet each and edger discs should be changed every 20 linear feet.

How do you know when you’re done sanding?

To know when you are done sanding, look at the wood in a low-angle reflected light. Or wet the wood then look at it from different angles. Before you apply your finish, raise the grain by wiping the surface with water. Then sand lightly to remove the nubs from the raised grain.

Why am I getting swirl marks when sanding?

A random orbital sander can leave swirl marks due to poor quality sandpaper, improper technique, or an inability to clear the dust from the surface.

What is the main purpose of a disc sander?

Made up of a circular abrasive paper, mounted on a circular plate; the disc sander is ideal for end grain work, shaping subtle round corners and removing large amounts of material quickly. The work is supported by a flat table which sits in front of the abrasive disc.

What kind of Sander do you use to sand pine floors?

Turn the belt sander around and finish the area. Keep on sanding the entire area of the pine floor. Using a hand disc sander, make sure to sand the corners and the area along the walls.

What kind of Sander should I use to avoid swirl marks?

I use a DeWalt sander and don’t have very many swirl issues and I don’t use a vacuum pickup. Vacuum, technique, a good sander and skill will keep the swirls down. If you want fast you will get swirl marks. Getting a fine sanding job done takes time. You can get better equipment to speed it up, but it still takes time.

What’s the best way to get rid of tearout?

Quilted maple, crotch-grained mahogany and waterfall bubinga are some other grain patterns that will present this problem. Again, shallow cutting passes will be helpful, but shifting to scraping or sanding methods (including thickness sanders) will be most successful. Helical cutterheads will also help enormously.

What kind of Sander to use for Woking off grid?

Woking off Grid. Use your shop sanders to help take the tedium out of the process of sanding. Asa Christiana put 10 midsize belt sanders to work flat-sanding both panels and edges, sanding curves and tight corners, and using the tool as a stationary sander while clamped to a benchtop.