Contents
What are the safety standards for power supplies?
Safety standards identify different classes of equipment depending on how their power supplies, especially mains units, isolate secondary circuits and accessible parts from dangerous ac mains voltages: Equipment achieves electric shock protection through basic insulation and protective earth grounding.
What’s the voltage limit for a 60 volt power supply?
Any voltage exceeding 42.2 Vac peak or 60 Vdc without a limited current circuit. A voltage in a secondary circuit not exceeding 42.4 Vac peak or 60 Vdc, the circuit being separated from hazardous voltage by at least basic insulation.
What are the requirements for a power supply?
Single insulation system applied to live parts which provides a degree of protection against electric shock equivalent to double insulation. For power supplies, the minimum insulation requirements are: Primary to secondary: Reinforced insulation with a minimum dielectric strength of 3000 Vrms.
How does a power supply provide shock protection?
Equipment achieves electric shock protection through basic insulation and protective earth grounding. This requires all conductive parts that could assume a hazardous voltage in the event of basic insulation failure to be connected to a protective earth conductor.
What are the safety requirements for an UL 1310 power supply?
The safety requirements of UL 1310 are defined in terms of: Enclosure strength and rigidity to resist likely abuses. Built-in over current and over-temperature protection devices. A maximum potential of 42.4 Vac peak / 60 Vdc for exposed wires / terminals.
Are there any regulations for medical device batteries?
In addition to battery specific standards, there are standards that include battery requirements in the dental, ophthalmic, and physical medicine fields. These currently include, but are not limited to:
Who is responsible for the safety of batteries?
The responsibility for battery safety starts at the cell maker’s premises and continues through to the design of the battery application. A multi-level safety plan should include consideration of at least the following components. Manufacturer’s quality systems. Process controls. (In place and being implemented)