Contents
What are the three main rules you need to follow when using the miter saw?
Miter Saw Safety
- Unplug the saw when you’re changing the blade or not using it.
- Keep your fingers at least 6 in.
- Wear safety glasses and hearing protection when you’re operating the saw.
- Don’t reach under the blade while it’s spinning.
- Let the blade come to a complete stop at the end of each cut before lifting it.
Should you wax your table saw?
There’s more to waxing than just making your table saw look pretty. You should wax your table because it will be easier to clean, reduce the chances of oxidation, and perhaps most importantly it reduces friction. Waxing your table saw is a feel-good thing.
Does a miter saw need oil?
DeWALT miter saws should be lubricated for better performance. Compound miter saws are used to make angle cuts on many different types of lumber. DeWALT compound miter saws can become worn down and damaged over time from constant use.
How often should you change a miter saw blade?
They can last between 12 and 120 hours of continuous use, depending on the quality of the blade and material they’re used to cut.
Do you have to clean a miter saw cutting table?
Cleaning the Miter Saw Cutting Table and FenceThere is the tendency for some people to think that the cleaning work is done once they are done with the cleaning of their tool. The last thing they will do is to clean the saw cutting table and fence. This should not be the case.
What to do when your miter saw becomes hard to use?
Serious rust might also compromise the integrity of the rails and may need replacing. If you didn’t have any corrosion or you’ve finished the corrosion cleaning step, you need to wipe the area with a clean shop towel to remove any leftover dust or old lubricant.
Is it OK to use wet lubricant on miter saw?
I strongly suggest avoiding wet lubricants for most parts of your miter saw . The reason for this is a wet oil or grease will collect any sawdust and debris that comes near the part. This means that your lubrication won’t last as long and you’ll be back repeating these steps in the near future.
What to do when you cut throat with miter saw?
That’s a recipe for splintering on the bottom face. Use a straightedge to check whether or not your throatplate is flush with the saw table. If you find a gap, stick a few layers of tape down over the throatplate to build it up. Then, slice the blade through it, and leave the tape in place.