What causes a temperature gauge to stop working?

What causes a temperature gauge to stop working?

The most common cause of faulty temperature readings is a broken coolant temperature sensor (CTS). The part, which is normally located near a vehicle’s thermostat near the base of the radiator (consult your owner’s manual or repair guide) can get gunked up and fail. Disconnect the temperature sensor’s wiring connector.

Why is my temperature gauge stuck on cold?

Reasons the Temperature Gauge Reads Cold Another reason the temperature gauge could read cold is if the thermostat in the vehicle stays open. With the thermostat stuck open, the engine can be overcooled, causing a low temperature reading. If this is the case, the thermostat may need to be replaced.

How do I know if my AC temperature sensor is bad?

Symptoms of a Bad or Failing Evaporator Temperature Sensor (Switch)

  1. No cold air from the AC system. One of the first symptoms of a potential problem with the evaporator temperature switch is no cold air from the AC system.
  2. AC temperature fluctuates.
  3. AC compressor does not activate.

What are the signs of a bad evaporator?

A broken air conditioner may be a result of a faulty AC evaporator….4 Symptoms of a Bad or Failing Air Conditioning Evaporator

  • The cool air is weak or no cold air is blowing at all.
  • You notice a strange odor when using your AC system.
  • The AC compressor will not activate.
  • The AC temperature will vary.

Why does the temperature gauge on my AC stop working?

The temperature gauge dropping should not matter to the AC system as it only cares that the coolant temperature is below 253 degrees. However it could be a symptom of the problem. As you can disconnect the battery and it suddenly resets I suspect there is a code being stored in the HVAC module that is pointing at what is shutting the system down.

Why does my car a / C stop blowing cold air?

Drove it around for about 10 mins and the car stayed at 210 on the gauge (as it should) and the a/c worked fine. This lasted for 2 days and then it went back to dropping the water temp, killing the a/c. My thoughts are of course electrical. The temp gauge can’t fluctuate that drastically without it being some sort of circuit/relay/sensor issue.

What to do if your a / C is not working?

Jesus S suggestion work. I had the same problem. A/c was blowing cold air for a few minutes then stopped blowing cold air but blow motor was blowing hot air. Next the temperature gage was not working. Disconnected battery for a few minutes and reconnected and the temperature gage is working and the a/c appears to be working.

Why is the temperature gauge on my trailblazer not working?

My question is to Ken the Administrator. In a previous blog about 2008 Trailblazer with a temperature gauge intermittently not working and setting code 128, you stated that it traces back to the BCM. Could you kindly explain how the BCM controls this?