Contents
What does code P2104 mean?
throttle actuator control
P2104 is an OBD-II generic code for the engine control module (ECM) detecting a major failure in the throttle actuator control (TAC) system causing the ECM to go into failure mode forced idle and limiting the engine to an idle RPM limit only. The throttle will not respond to any increase in throttle.
How do I fix error code P2107?
What repairs can fix the P2107 code?
- Repairing or replacing throttle body actuator wiring harness.
- Replacing throttle body.
- Fixing poor electrical connection.
- Replacing throttle position sensor.
What does engine code P2111 mean?
throttle actuator control system
The error code P2111 usually refers to the throttle actuator control system which is stuck open. Depending on the driver’s request for power, the throttle motor will open and close the throttle plate by allowing more or less air to pass through the engine. The engine computer controls the throttle motor.
How do I know if my throttle actuator is bad?
Symptoms of a Bad or Failing Throttle Kicker Actuator
- Throttle hesitation. Most of the time, the engine responds to throttle pressure applied by the driver without stumbling or hesitation.
- Poor fuel economy.
- Engine stalling often.
How much does it cost to fix throttle control?
The average cost for a Throttle Body Replacement is between $489 and $593 but can vary from car to car.
When is the P2104 code set for forced idle?
This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle. The P2104 code is set when the Throttle Actuator Control (TAC) system is in the Failure Mode Effects Management (FMEM) mode of forced idle.
What does the P2104 throttle actuator control system do?
Replacing or cleaning ABS sensor Replacing or cleaning EGR Valve Replacing or cleaning Mass Airflow sensor Cleaning corrosion from connectors Repairing or replacing wiring Flashing or replacing PCM
What does the OBD code P2104 stand for?
P2104 is an OBD-II generic code for the engine control module (ECM) detecting a major failure in the throttle actuator control (TAC) system causing the ECM to go into failure mode forced idle and limiting the engine to an idle RPM limit only. The throttle will not respond to any increase in throttle.
When is the P2104 Ford TAC code set?
The P2104 code is set when the Throttle Actuator Control (TAC) system is in the Failure Mode Effects Management (FMEM) mode of forced idle. Need more information on how to fix the P2104 FORD code?