Contents
What does show MAC address table do?
Each host connecting to a switch port will have its MAC address entered into the switch’s MAC address table. The MAC address table is a way to map each port to a MAC address. This makes it efficient to forward traffic directly to a host.
What is the MAC address table?
A MAC address table, sometimes called a Content Addressable Memory (CAM) table, is used on Ethernet switches to determine where to forward traffic on a LAN.
Can a MAC address table have more than one MAC address associated with an interface?
You can have more than one MAC address on a switch port if: You have a switch connected to it. Could be another managed switch (like a Cisco) or an unmanaged switch (like a consumer Netgear or Linksys switch). You have a virtual server host attached to it with multiple virtual machines sharing the NIC.
What information is stored in the switch’s MAC address table?
The switch enters the source MAC address of PC 3 and the port number of the ingress port into the address table. The destination address of the frame and its associated egress port is found in the MAC address table (Figure 1-17).
How can I get packet tracer to recognize my MAC address?
For example, go on the PC and do a “Ipconfig /renew” in the Command Terminal and then it will appear. You are correct, but for some reason Packet Tracer won’t recognize it until you try to send a frame through to the switch. For example, go on the PC and do a “Ipconfig /renew” in the Command Terminal and then it will appear.
How to show MAC address table in Cisco?
Total Mac Addresses for this criterion: 3 SW6#show mac address-table interface fa0/14 Mac Address Table Vlan Mac Address Type Ports 1 0018.7330.7e08 DYNAMIC Fa0/14 1 aaaa.aaaa.aaaa DYNAMIC Fa0/14 <<<<<<<<<<< dynamic???
How to show MAC address table in SW6?
But when I issue the “show mac address-table” command, the switch only shows the usual “STATIC CPU” addresses, and not the DYNAMIC ones, which are those of the SW7’s interfaces. See this: SW6#sh mac address-table
How to send fragments from a MAC address?
The lab show me a source mac address AAAA and a destination mac address BBBB Whitch interfaces will be use to send the fragments. I use the show mac address-table and could find only mac address AAAA on the address-table, the mac address BBBB is not present.