Contents
What does the dot mean on a capacitor?
The motor Capacitor Terminals are identified. Is that correct? The terminal with an arrow, a painted dot, or a dash in the can will be identified by the manufacturers. The terminal is near the metal container or can and marks the connection to the plate.
What are the terminals on a start capacitor?
On many systems these terminals may be labeled so that the three leads on a start/run capacitor can be wired correctly: S = start wire connector. R = Run wire connector. C = common connector.
What is the first step in testing a capacitor?
The first and most simple is to inspect the capacitor. If it appears “blotted” or swelled, it is a safe bet that it is bad. It is good practice to go ahead and perform the following test even though it is swelled. Make a sketch of the wires connected to the capacitor and note the colors or numbers that identify them.
How many characters are in a capacitor marking code?
Abbreviated capacitor marking codes: Smaller capacitors may only have room for a few figures printed as a code for the value. This capacitor marking code uses three characters. It bears many similarities to the numeric code system adopted for some surface mount resistors.
Are there markings on SMD ceramic capacitors?
SMD ceramic capacitor codes: Surface mount capacitors are often very small and do not have the space for markings. During manufacture the capacitors are loaded into a pick and place machine and there is no need for any markings.
What does the stripe mean on an electrolytic capacitor?
On an electrolytic capacitor the stripe indicates the negative lead. In this case the marking stripe also has a negative sign on it to reinforce the message. If the capacitor is an axial version having leads at both ends of the package, the polarity marking stripe may be accompanied by an arrow that points to the negative lead.
What is the code for a surface mount capacitor?
Often the value may be given in picofarads. Sometimes figures such as 10n will be seen and this indicates a 10nF capacitor. Similarly n51 indicates a 0.51nF, or 510 pF capacitor, etc . . SMD ceramic capacitor codes: Surface mount capacitors are often very small and do not have the space for markings.