What grease to use on GM slip yoke?

What grease to use on GM slip yoke?

Registered. 4 wheel drive slip yoke should ONLY be lubed with ATF. Grease can migrate into the transfer case because the seal only keeps ATF in but will allow the grease to enter the Transfer Case and could cause problems if the grease is not compatible with the transfer case fluid.

Do you grease drive shaft?

So initially, all you need to do is install it. Down the road however you will need to grease your drive shaft to ensure a long life. A good guideline to start with is to grease your shaft every oil change. If you go wheeling and drive through a lot of dirt or water, grease your shaft as soon as you get home.

Do you grease slip yoke?

“For those that don’t know, It is EXTREMELY important that you not put too much grease into the slip yoke. Filling this area completely with grease prevents the driveshaft from shortening with normal suspension movement.

Can I spray WD40 on my driveshaft?

Re: Wd40 on the stock rear drive shaft, Will it hurt anything? WD40 isn’t a lubricant and shouldn’t be used as one. It will actually take good oil away from moving parts. Use spray silicone or a light oil for bearings and joints..

How do I know if my slip yoke is bad?

Clunking sound, when going from acceleration to deceleration or deceleration to acceleration, may be caused by slip yoke problems. The splines may be worn. The yoke transmission extension housing bushing may also be worn. This will let the yoke move up and down with changes in drive line torque.

What type of lubricant grease can be used on universal joints?

What type of grease should I use to lubricate my universal joints equipped with grease fittings? A good quality lithium complex soap based EP (Extreme Pressure) grease with a NGLI grade of 1 to 2 is recommended.

What are the signs of a bad slip yoke?

Grinding and squeaking sounds from the drive shaft are frequently caused by worn universal joints. The joints become dry, causing the rollers to wear. Clunking sound, when going from acceleration to deceleration or deceleration to acceleration, may be caused by slip yoke problems.

What should the temperature be for high temperature grease?

High Temperature E.P. High Temperature E.P. Grease with Syncolon® (PTFE) Super Lube® High Temperature Extreme Pressure (E.P.) Grease is a NLGI Grade 2 grease for use in those applications that require a higher concentration of Syncolon® (PTFE) and a temperature range from -30°F to 475°F (-34°C to 246°C).

When do you use PTFE Grease in a machine?

Use this general purpose grease to lubricate most machinery. Formulated to adhere to metal parts and stay in place in wet environments, this grease is commonly used in pulp and paper manufacturing and water management facilities. Waterproof and heat- resistant, this grease can be autoclaved without washing out of equipment.

What kind of grease to use on slip yoke?

The grease is specifically designed to be used on slip yoke, i.e., the front portion of the drive shaft that goes into the transmission. It can be used on all motor vehicles, marine settings, and household applications.

Which is high temperature Syncolon or Super Lube?

Super Lube® High Temperature E.P. Grease with Syncolon® (PTFE) is NLGI GC-LB Certified. Super Lube® High Temperature E.P. Grease is Kosher Certified.