Contents
What is bandwidth How much do you need?
For most households: At least 3 Mbps upload bandwidth, or at least 10% of your download bandwidth. For heavy use of cloud backup or gaming: 5-10 Mbps, or at least 20% of your download bandwidth. For households that share a lot of pictures or actively upload or stream video: 5-10 Mbps upload speeds would be more useful.
How do you measure the bandwidth of a system using sinusoidal test signals?
To measure the bandwidth of a driver, put in a sinusoidal setpoint that peaks at one volt, then increase the frequency of the sinewave until only half a volt of equivalent setpoint comes out. That’s the 3dB bandwidth.
What means oscilloscope bandwidth?
Oscilloscope bandwidth is defined as the frequency at which the amplitude of the observed signal drops by -3 dB (or drops to 70.7% of its actual value) as we increase the test signal’s frequency as plotted on the amplitude-frequency characteristic curve (Figure 1).
How much bandwidth do you need for a 12 MHz oscilloscope?
Bandwidth — to measure the 12 MHz signal, we need an absolute minimum of 12 MHz, but this will give a very distorted signal so a scope with at least 50 MHz bandwidth would be sensible. Sampling rate — to reconstruct the 12 MHz signal we need around 5 points per waveform, so a minimum sampling rate of 60 MS/s is required.
What should be considered when choosing an oscilloscope?
The first feature to consider is bandwidth. This can be defined as the maximum frequency of signal that can pass through the front-end amplifiers. It therefore follows that the analog bandwidth of your scope must be higher than the maximum frequency that you wish to measure (real-time).
How do I determine what bandwidth of scope I require for?
Oscilloscope bandwidth is defined as the frequency at which the amplitude of the observed signal drops by -3 dB (or drops to 70.7% of its actual value) as we increase the test signal’s frequency as plotted on the amplitude-frequency characteristic curve (Figure 1).
What does 0 dB mean on an oscilloscope?
The 0 dB level is the level of the peak of the scope response. Today bandwidth in the context of the oscilloscope is taken to mean the maximum frequency that can transverse the front end without significant attenuation, defined as 70.7% (-3 dB) of the original signal.