Contents
What is displayed on the upper ECAM?
The ECAM System presents airplane engine and system data on two identical CRT displays located on the center instrument panel below the glareshield. The upper screen is the Engine/Warning Display (E/WD) and the lower screen is the System Display (SD). Primary engine instruments information and fuel quantity indication.
What does A320 measure?
320nm: A320 provides a general measurement of the turbidity of the sample and is normally subtracted from the A260 value as a background reading for the calculation of DNA concentration, but excessive values may indicate non-specific contamination.
What does the ECAM do on an a320f?
The ECAM displays APU parameters. driving the accessory gbx (electrical generator, starter, etc.) and produces bleed air (engine starting and pneumatic supply). ‐ Sequences the start and monitors it. ‐ Monitors speed and temperature. ‐ Monitors bleed air. ‐ Sequences the shutdown. ‐ Controls the automatic shutdown.
How does SDAC work on an Airbus A320?
On the Airbus A320 the System Data Acquisition Concentrators (SDAC) aquire system data, process it and sends system page data to the three Display Management Computers (DMC). The DMC process the data and generate an image.
How does fuel monitoring work on an A320?
Do not provide pilots with a continuous indication of the fuel quantity in the wing tanks, but only the signal that the fuel level has reached below 750 kg (threshold crossed). The information provided to pilots in the form of the low level alert results from a physical measure (sensors dry or wet) rather than from a calculation.
How much fuel is in the A320 fuel tank?
The A320 Family aircraft low level indication is based on remaining fuel quantity in the tank being sufficient to meet the requirement of 30 minutes at 1500 ft (corresponding to approximately 1 200 kg). Should the low level alert trigger on both fuel tanks, the total remaining fuel is: 750kg + 750kg = 1 500 kg.