Contents
What is external interrupt stm32?
The Cortex M3 based MCUs have a sophisticated and yet easy to use interrupt system called the Nested Vectored Interrupt Controller (NVIC). It ensures low latency and high performance. There are several features of the NVIC and these are handled by the compiler.
How many external interrupts are in atmega328p?
The ATmega 328P supports two external interrupts which are individually enabled by setting bits INT1 and INT0 in the External Interrupt Mask Register (Section 12.2.
Where can you find the interrupt vector table IVT )?
In summary, the interrupt vector table is an array of function pointers that points to the starting address of exception or interrupt handlers of a microcontroller or microprocessor. IVT usually stores at the starting addresses of flash or code memory.
Is there an external interrupt system for STM32?
The interrupt system of STM32 is not too much complex and only a few registers need to be taken care of after setting GPIO pins. The first thing to do is to setup which EXTI lines to use and which port pins to use.
Besides, EXTI0 and EXTI1 share the same interrupt handler (vector EXTI0 1 in the vector table) so just need to make sure that you check which one is triggered inside the handler (not mentioned in the video). Moreover, EXTI2 and EXTI3 share the EXTI2 3 handler and EXTI4 to EXTI15 will share the EXTI4_15 handler.
How are external interrupts used in microcontrollers?
To get rid of these issues, we’ll need to use external interrupts – a vital feature in every common microcontroller. STM32F1xx series are ARM Cortex M3 based MCUs. The Cortex M3 based MCUs have a sophisticated and yet easy to use interrupt system called the Nested Vectored Interrupt Controller ( NVIC ). It ensures low latency and high performance.
What are the ports on the Bluepill STM32F103?
On bluepill you have available ports A, B and C. The STM32F103 has also port D, with only two pins used for XTAL oscillator. I wired my button and LED to pins of port B.