Contents
What is HSRP tracking?
Interface tracking allows you to specify another interface on the router for the HSRP process to monitor in order to alter the HSRP priority for a given group. …
What is IP SLA configuration?
IP SLA config sets up IP SLA (Service Level Agreement Monitor) as active monitoring feature which allows to determine connectivity in two ways. Firstly, by checking IP destination availability. IP SLA config is commonly used for performance statistics like Delay, Jitter or Packet Loss in SP and Enterprise environments.
What is the purpose of HSRP?
Hot Standby Router Protocol (HSRP) is a CISCO proprietary protocol, which provides redundancy for a local subnet. In HSRP, two or more routers gives an illusion of a virtual router. HSRP allows you to configure two or more routers as standby routers and only a single router as active router at a time.
When to use IP SLA with HSRP-IP?
P indicates configured to preempt. P indicates configured to preempt. P indicates configured to preempt. As seen above , combination of HSRP and IP SLA will make a good solution when we have multiple Routers running HSRP and where we need to detect any indirect link failure or Layer 1 link failure to reroute the traffic via backup HSRP Router.
How to track an IP route in HSRP?
! track 1 ip route 0.0.0.0 0.0.0.0 reachability >>>>>>> Track to verify whether default route is being learnt via BGP! standby 1 track 1 decrement 20 >>>>>>> Decrement by 20 when tracked route is not available
Is it possible to statetrack with IP SLA?
Active HSRP router is BGP router. Standby is Eigrp Router. I want to track if my ISP1 goes down or somehow I lost the bgp peering or bgp routing is empty then HSRP state should fallback to standby & eigrp router should take role of Atcive HSRP router. Is it possible with IP SLA, if yes how ? 06-15-2009 01:12 PM 06-15-2009 01:12 PM
Are there any routers that have HSRP configured?
Routers R1 and R2 have HSRP configured on LAN side (HSRP IP = 192.168.12.3). Both the routers have static routes pointing towards R3 on the remote side.