Contents
What is library 09-i2c for STM32F4?
Library 09- I2C for STM32F4. I2C or Inter-Integrated Circuit is a multimaster serial single ended bus. This protocol is commonly used with RTC modules, temperature sensors, EEPROMs, IO expanders and more. I2C protocol uses 2 wires: Both wires need external pull up resistor, from about 4k7 to 47k, if you don’t use pull up resistors in MCU.
Why is stm32-i2c returning busy or error?
Using Configure_IO after Configure_Alternate_Function crushes the configuration and, as there was a part of the record which was left uninitialized, the GPIO were incorrectly configured.
How is the I2C protocol used in RTC modules?
I2C or I nter- I ntegrated C ircuit is a multimaster serial single ended bus. This protocol is commonly used with RTC modules, temperature sensors, EEPROMs, IO expanders and more. I2C protocol uses 2 wires:
How does the get id command work in STM32?
The Get ID command is used to get the version of the chip ID (identification). When the bootloader receives the command, it transmits the product ID to the host. The STM32 device sends the bytes as follows: Byte 1: ACK Byte 2: N = the number of bytes – 1 (for STM32, N = 1), except for current byte and
Why is the I2C pin not moving on STM32?
If the pin is not moving you should check the other end of the I2C pins. Perhaps it’s an output to 0 stretching down the line. If it’s not connected, try to configure the pin as an output and move it to exclude HW problems (you can do it directly in debug, with the keil interface you have in the screenshots).
What kind of interface does STM32 microcontroller have?
The STM32 line of microcontrollers are a popular implementation of the ARM Cortex-M core from STMicroelectronics. As with most microcontrollers, almost all STM32 parts come equipped with 1 (or more!) I2C interfaces. If you have not set up STM32CubeIDE with your Nucleo board, you will need to do so following the steps outlined in this tutorial.
Can a STM32 function end with _ it ( )?
Take a look at the HAL API documentation for your particular board, and you’ll notice that there are lots of other I2C functions. The functions that end with _IT () rely on hardware interrupts within the STM32, which means you can construct non-blocking versions of our I2C communication.