What is MII RMII?
MII vs RMII for Ethernet Therefore, RMII (reduced MII) was developed as a variant of MII to cut the number of unshareable signals per PHY interface in half (down to 8 per PHY). The RMII specification is also capable of supporting 10 Mbps and 100 Mbps data rates, and there are gigabit-capable variants.
Why is PHY used?
Its purpose is to provide analog signal physical access to the link. It is usually interfaced with a Media Independent Interface (MII) to a MAC chip in a microcontroller or another system that takes care of the higher layer functions.
What does Ethernet PHY do?
The Ethernet Physical Layer (PHY) is responsible for the physical link between the Ethernet controller and the network. This layer is onchip on the FT900 so only the differential signals are available at pin level. The magnetics allow different nodes on the Ethernet network to connect over long distances.
How does a PHY chip work?
A PHY connects a link layer device (often called MAC as an acronym for medium access control) to a physical medium such as an optical fiber or copper cable. A PHY device typically includes both Physical Coding Sublayer (PCS) and Physical Medium Dependent (PMD) layer functionality.
What is the difference between RM2 and RMII?
It is not to be confused with RM2. Reduced media-independent interface (RMII) is a standard which was developed to reduce the number of signals required to connect a PHY to a MAC.
What kind of impedance is needed for RMII?
The RMII signals are treated as lumped signals rather than transmission lines. However, the IEEE version of the related MII standard specifies 68 Ω trace impedance. National recommends running 50 Ω traces with 33 Ω series termination resistors for either MII or RMII mode to reduce reflections.
Can you connect a Mac to a RMII switch?
I’ve done some Googling and am aware that RMII isn’t designed to work between two MACs. The datasheet for the Microchip switch refers to the RMII interface supporting both MAC and PHY modes but doesn’t explain how to configure this. Every example reference design I’ve seen on the internet has it set up as a MAC.
How does RMII differ from Mii and SNI?
RMII requires a 50 MHz clock where MII requires a 25 MHz clock and data is clocked out two bits at a time vs 4 bits at a time for MII or 1 bit at a time for SNI (10 Mbit/s only). Data is sampled on the rising edge only (i.e. it is not double-pumped ).