What is pulse train generator?

What is pulse train generator?

The Pulse Train Generator for NI-RFSG is a software add-on for LabVIEW that provides pulse sequence generation featuring compatibility with PXI RF Analog Signal Generators, PXI Vector Signal Generators, and the RF outputs of the PXI Vector Signal Transceiver.

What are the essential parts of impulse current generator?

The essential parts of an Impulse Current Generator Output Waveform are:

• a d.c. charging unit giving a variable voltage to the capacitor bank,
• capacitors of high value (0.5 to 5 μF) each with very low self-inductance, capable of giving high short circuit currents,
• an additional air cored inductor of high current value,

What do I need to make a Marx generator?

And you may need other common tools for this project… The marx generator requires a low-current, high voltage DC in the range 4-8KV power supply. Small, low-current HV power supplies are found in things like ionisers (air purifiers), photocopiers and laser printers, those should be suitable.

Is the Marx generator dangerous after power is turned off?

The marx generator will also be dangerous after the power is turned off, because the capacitors will hold a lethal charge in them, so, MAKE ABSOLUTELY SURE YOU DRAIN ALL THE CAPACITORS BEFORE YOU TOUCH THE DEVICE!!! Otherwise you will get a ‘surprise shock’ form the capacitors which can seriously harm you or even death…

How do you wire a generator to a house?

The electrician can also switch out the main breaker and an additional double-pole breaker with an interlock device and wire the generator directly to that. In the case of a power outage, simply lift the interlock lever, power the generator on, and then select the circuits you want powered on.

Where are the spark gaps in the Marx generator?

To deliver 5 ns rise time pulses, the Marx generator is often built into a coaxial wave guide. The spark gaps are placed as close as possible together for maximum UV light exchange for minimum jitter. DC HV comes from underneath, pulsed HV leaves at the top into the coaxial line.