Contents
What is the difference between ifconfig and IP address command?
Functionality: The ipconfig command displays all the currently connected network interfaces whether they are active or not. On the other hand, the ifconfig command displays only the enabled network interfaces that are connected to the system.
How do I change my ifconfig Gateway?
How to Manually Set Your IP in Linux (including ip/netplan)
- Set Your IP Address. ifconfig eth0 192.168.1.5 netmask 255.255.255.0 up. Masscan Examples: From Installation to Everyday Use.
- Set Your Default Gateway. route add default gw 192.168.1.1.
- Set Your DNS Server. Yes, 1.1. 1.1 is a real DNS resolver by CloudFlare.
What is ifconfig command used for?
Description. You can use the ifconfig command to assign an address to a network interface and to configure or display the current network interface configuration information. The ifconfig command must be used at system startup to define the network address of each interface present on a system.
How to use the IP command instead of ifconfig?
How to use the ip command instead of ifconfig 1 Show network devices 2 Enable a network interface 3 Setting IP address 4 Delete an IP address 5 Add alias interface 6 Add an entry in the ARP table. 7 Show the routing table 8 Changing the routing table 9 References More
How to re-enable an interface in ifconfig?
To re-enable the interface, just replace down by up. The below ip command is alternative for ifconfig to disable a specific interface. This can be verified by the output of ‘ip a’ command which shows all the interfaces by default, either up or down, but highlights their status along with the description.
Can a device be set up using ifconfig eth0?
Furthermore, you can set devices up or down (similar to ifconfig eth0 up or ifconfig eth0 down) simply by using: As shown above, there are lots of other objects that can be interacted with using the ip command. I’ll cover another: ip route, in another post.
Is there an alternative to ifconfig in Linux?
ip – A Replacement for ifconfig ifconfig has been there for a long time and is still used to configure, display and control network interfaces by many, but a new alternative now exists on Linux distributions which is much more powerful than it. This alternative is ip command from iproute2util package.