What is the drive cycle for Toyota Corolla?
Drive the vehicle at a steady speed between 43 & 56 mph (70-90 km/h) for three to five minutes. Stop the vehicle and idle the engine for 3-5 minutes. Repeat steps 1-3 once. Notes: Readiness may not switch to complete if a pending code was set during the drive trace.
What is a Toyota drive cycle?
Some vehicles have very specific drive cycles that must be followed before the catalyst monitor will run. Toyota: The catalytic converter monitor will run after driving the vehicle at 40 to 55 mph for seven minutes, followed by driving at 35 to 45 mph for another seven minutes.
How long is an OBD drive cycle?
Preparation for it will take eight hours but, all in all, a basic drive cycle test should take around 30 minutes to complete, with about 20 minutes of actual driving. Understanding your vehicle’s overall health can help you ensure it drives smooth and lasts long.
What does the drive cycle look like on a Toyota Corolla?
This site includes a post with the specific drive cycle that resets the OBD-II monitors on several 2000-2002 Toyota vehicles. What does the drive cycle look like for a 2003 Toyota Corolla?
How long does a Toyota OBD-II drive cycle take?
Drive the vehicle at a steady speed between 40-55 mph (64-88 km/h) or more for 7 minutes if IAT was below 50E F (10E C) at start-up, or 3 minutes if IAT was above 50E F (10E F) at start-up. Drive the vehicle at 35-45 mph (56-72 km/h) for 7 minutes. NOTES: Maintain smooth throttle inputs, avoiding sudden accelerations.
What should IAT be for Toyota OBD-II?
IAT (Intake Air Temperature) must be 14E F (-10E C) or more. (2002 MY vehicles will run monitor at temperatures below 14E F by cycling key to OFF and repeating drive trace). Connect Scan tool in order to observe data stream and monitor status. Note the IAT data for use in step 3.
How to do an OBD scan on a Toyota?
Connect Scan tool in order to observe data stream and monitor status. Start the engine and allow it to idle 2 minutes. Drive the vehicle at a steady speed between 40-70 mph (64-112 km/h) or more for 3 minutes. Maintain engine speed between 900 & 3,200 rpm. Stop the vehicle and allow it to idle for ten (10) seconds or more.