Contents
What is the function of probe in oscilloscope?
An oscilloscope probe is a device that makes a physical and electrical connection between a test point or signal source and an oscilloscope. Depending on your measurement needs, this connection can be made with something as simple as a length of wire or with something as sophisticated as an active differential probe.
What is X10 oscilloscope probe?
The most common type of probe with a built in attenuator gives an attenuation of ten, and it is known as a X10 oscilloscope probe. The 10X scope probe uses a series resistor (9 M Ohms) to provide a 10 : 1 attenuation when it is used with the 1 M Ohm input impedance of the scope itself.
How to find the probe resistance of an oscilloscope?
If the scope internal resistance R S = 1 MΩ, its capacitance is C S = 25 pF and the cable connecting the probe to the scope has capacitance C C = 150 pF, find the values of the required probe resistance R P and capacitance C P for 10:1 attenuation. Make sure that the same attenuation is also valid for dc measurements.
How are differential probes used in an oscilloscope?
Differential probes use a differential amplifier to convert the difference between two signals into a voltage that can be sent to a typical single-ended scope input. See Figure 8 below. Differential probes offer high common-mode rejection performance over a broad frequency range. Figure 8. Typical schematic of an active differential probe.
What kind of probe does a Keysight oscilloscope use?
Most Keysight oscilloscope probes offer either a BNC type of probe interface or the AutoProbe interface. The AutoProbe interface is an intelligent communication and power link between compatible probes and the Infiniium or InfiniiVision Series oscilloscopes.
Which is the best value to match a probe with a scope?
However, this value can range from 5pF up to 100pF. The best approach, for matching a probe with a scope, is to first choose a probe whose capacitance is within the range of your scope and then fine-tune the probe’s capacitance by adjusting its compensation network using the probe’s trimmer capacitor, if possible.