Contents
What is the highest security level can be applied to an ASA interface?
Security level 100
Security level 100: This is the highest security level on our ASA and by default this is assigned to the “inside” interface. Normally we use this for our “LAN”. Since this is the highest security level, by default it can reach all the other interfaces.
How does Asa work in Traceroute?
The ASA, being a security device, deliberately tries to ‘hide’ from the traceroute. It is able to do this, as it does not decrement the TTL of a packet or segment that passes through it. This means that it does not send back an ICMP TEM, and therefore does not appear in the traceroute list.
What is the security level of inside and outside interface by default?
Security level 0
Security level 100—The highest possible level, it is used by the inside interface by default. Using the trusted-untrusted terminology, this level is considered the most trusted. Security level 0—The lowest possible level, it’s used by the outside interface by default, making it the most untrusted interface.
In which 2 modes does Asa work How are the 2 modes different?
ASA can perform static routing, Default routing also dynamic routing protocols like EIGRP, OSPF, and RIP. ASA can operate in two modes: Routed mode: In this mode, ASA acts like a layer 3 device (router hop) and needs to have two different IP addresses (means two different subnets) on its interface.
How do I enable ping in Asa?
By default all traffic from higher security zone such as “inside” going to lower security zone “outside” is allowed without the need of an ACL. Return traffic is allowed while the traffic was initiated from “inside”.
What are the levels of security?
The security features governing the security of an identity can be divided into three levels of security, i.e. Level 1 Security (L1S) (Overt), Level 2 Security (L2S) (Covert) and Level 3 Security (L3S) (Forensic).