Contents
What is the maximum distance the ultrasonic sensor can detect?
Ultrasonic sensors are suitable for close range detection up to ten meters and provide multiple range measurements per second.
What is the maximum range of ultrasonic sensor HC-SR04?
The HC-SR04 ultrasonic sensor uses SONAR to determine the distance of an object just like the bats do. It offers excellent non-contact range detection with high accuracy and stable readings in an easy-to-use package from 2 cm to 400 cm or 1” to 13 feet.
How accurate is HC SR04?
HC-SR04 Hardware Overview
| Operating Voltage | DC 5V |
|---|---|
| Min Range | 2cm |
| Ranging Accuracy | 3mm |
| Measuring Angle | 15 degree |
| Trigger Input Signal | 10µS TTL pulse |
What is the range of ultrasonic?
The term “ultrasonic” applied to sound refers to anything above the frequencies of audible sound, and nominally includes anything over 20,000 Hz. Frequencies used for medical diagnostic ultrasound scans extend to 10 MHz and beyond.
What is the output of HC-SR04?
5V
The HC-SR04 has a 5V output (which needs to be reduced to 3.3V to work with the Raspberry Pi). The HC-SR04 sensor works best between 2cm – 400 cm (1″ – 13ft) within a 30 degree cone, and is accurate to the nearest 0.3cm.
How does the ultrasonic sensor hc-sr04 work?
Ultrasonic Sensor HC-SR04 is a sensor that can measure distance. It emits an ultrasound at 40 000 Hz (40kHz) which travels through the air and if there is an object or obstacle on its path It will bounce back to the module. Considering the travel time and the speed of the sound you can calculate the distance.
What are the configuration pins for the hc-sr04?
The configuration pin of HC-SR04 is VCC (1), TRIG (2), ECHO (3), and GND (4). The supply voltage of VCC is +5V and you can attach TRIG and ECHO pin to any Digital I/O in your Arduino Board. Ultrasonic Sensor HC-SR04 Configuration and Specification. Ultrasonic Sensor HC-SR04 Principle.
How big is the path of the hc-sr04?
The HC-SR04 barely works to 10 feet giving a total path length of 20 feet and a path time of about 20ms so set the timeout to something above that, say 25 or 30ms. If you put a resistor, say 2k2 between E and T then only connect to T you can use the HC-SR04 from just one Arduino pin.
How to use an ultrasonic distance sensor with Arduino?
How to use a HC-SR04 Ultrasonic Distance Sensor with Arduino. The HC-SR04 is an inexpensive, easy to use distance sensor, with a range of 2 to 400cm. It is commonly used in obstacle avoiding robots and automation projects.