What is the show interface status command?
The show ip interface command provides tons of useful information about the configuration and status of the IP protocol and its services, on all interfaces. The show ip interface brief command provides a quick status of the interfaces on the router, including their IP address, Layer 2 status, and Layer 3 status.
Which command would you use to display the status of all interfaces on a Cisco router?
show interfaces EXEC command
Use the show interfaces EXEC command to display statistics for all interfaces configured on the router or access server.
How do you show interface configuration?
To display the running configuration for a specific port channel, use the show running-config interface command.
Is there alternative command for show interface status on a switch?
Is there any alternative command for show interface status on a switch? In packet tracer (A simulation), show interface status is not working. However, in GNS3 and real Cisco switches this command will work fine.
How to check the status of an interface?
The status of an interface on a Cisco switch can be checked using the show interface TYPE exec mode command. Consider the following example: SW1#show interfaces fa0/1 FastEthernet0/1 is up, line protocol is up (connected) Hardware is Lance, address is 0040.0b21.0b01 (bia 0040.0b21.0b01) BW 100000 Kbit, DLY 1000 usec, reliability 255/255,
Is there a command to show the interface?
The only command I can suggest to you would be “show ip interface brief” which will not show you the speeds though. This is mainly used to display ip addresses assigned to layer 3 ports. Alternatively, you just need to use “show interface” and view all the details of the port.
How to show interfaces status with no arguments?
show interfaces status command with no arguments. Specify a particular module number to see information on the ports on that module only. Enter both the module number and the port number to see detailed information about the specified port. To apply configuration commands to a particular port, you must specify the appropriate logical module.