What is wing strut?

What is wing strut?

Interplane struts hold apart the wings of a biplane or multiplane, also helping to maintain the correct angle of incidence for the connected wing panels.

What is the wire on top of a plane?

The sense antenna is the long wire that runs normally from the top of the tail to the top of the cabin. This antenna is sometimes located on the bottom of the aircraft, especially on larger aircraft.”

Why is it called a biplane?

A biplane is a fixed-wing aircraft with two main wings stacked one above the other. Biplanes are distinguished from tandem wing arrangements, where the wings are placed forward and aft, instead of above and below. The term is also occasionally used in biology, to describe the wings of some flying animals.

What is externally braced aircraft?

External Structure A braced wing uses external structural elements to help carry wing loads. These external elements can be either struts that are rigid and can carry both tension and compression loads, or wires that can only carry tension.

What is the function of a strut?

Shocks and struts help stabilize your vehicle’s movements, enhancing control when you turn, brake, accelerate or encounter uneven road surfaces. Today’s vehicles use shocks, struts or a combination of the two.

What material is used in aircraft construction?

The most common metals used in aircraft construction are aluminum, magnesium, titanium, steel, and their alloys. An alloy is composed of two or more metals. The metal present in the alloy in the largest amount is called the base metal. All other metals added to the base metal are called alloying elements.

What is a monoplane?

: an airplane with only one main supporting surface.

What is a semi cantilever wing?

Many high-wing airplanes have external braces, or wing struts, which transmit the flight and landing loads through the struts to the main fuselage structure. Since the wing struts are usually attached approximately halfway out on the wing, this type of wing structure is called semi-cantilever.

What is the strongest part of the wing?

The strongest wing structure is the full cantilever which is attached directly to the fuselage and does not have any type of external, stress-bearing structures. The semi-cantilever usually has one, or perhaps two, supporting wires or struts attached to each wing and the fuselage.

What is Max camber?

Maximum camber is the maximum distance of the mean camber line from the chord line; Maximum thickness is the maximum distance of the lower surface from the upper surface.

What do you need to know about aircraft rigging?

Rigging also includes the safetying of the attaching hardware using various types of cotter pins, locknuts, or safety wire. The Type Certificate Data Sheet (TCDS) is a formal description of an aircraft, engine, or propeller.

Why are nylon cables used in aircraft rigging?

By adding the nylon coating to the corrosion resistant steel cable, it increases the service life by protecting the cable strands from friction wear, keeping dirt and grit out, and dampening vibration which can workharden the wires in long runs of cable. Cable construction—the basic component of a cable is a wire.

How are ailerons attached to the vertical stabilizer?

Ailerons are attached to the wings, elevators are attached to the horizontal stabilizer, and the rudder is attached to the vertical stabilizer. Rigging involves setting cable tension, adjusting travel limits of flight controls, and setting travel stops.

What do you need to rig a flight control system?

The flight control system must be adjusted (rigged) to obtain these requirements. The tools for measuring surface travel primarily include protractors, rigging fixtures, contour templates, and rulers. These tools are used when rigging flight control systems to assure that the desired travel has been obtained.