What kind of software is used on Altera Cyclone IV?
The procedure introduced in this application note was verified on the Altera Cyclone IV and Cyclone V Development Board, using Quartus II 13.0sp1 Web Edition software, and updated with Quartus Prime 17.0. In general, the procedure should apply to all other versions of Quartus software.
How to program Cypress SPI flash on Altera board?
In-System Programming for Cypress SPI Flash on Altera® FPGA Board AN98558 introduces an alternate method to in-system program the Cypress SPI flash by using Altera’s Nios®II tool, which works with all versions of the Quartus II software. 1 Introduction
How does Quartus 2 debug an FPGA design?
This chapter of the Quartus II Development Software Handbook provides a description of the verification flow using the SignalTap II embedded logic analyzer. The SignalTap II embedded logic analyzer debugs an FPGA design by probing internal signals in the design while the design is running at full speed.
What kind of software is used to debug FPGAs?
The SignalTap II embedded logic analyzer debugs an FPGA design by probing internal signals in the design while the design is running at full speed. This chapter of the Quartus II Development Software Handbook provides information about the logic analyzer interface feature.
How do I update my Altera USB Blaster driver?
Right mouse click on this and then select Properties. Select the Hardware tab and select Properties. A new window should pop up with the General tab already selected. Select Change Settings. Again a new window should pop up with the General tab already selected. Select Update. Select Browse my computer for driver software.
Where is the USB Blaster on the control panel?
Open the Device and Printers (Control Panel | Devices and Printers). Under Unspecified, USB Blaster should be listed. Right mouse click on this and then select Properties. Select the Hardware tab and select Properties. A new window should pop up with the General tab already selected.