What range of angles can a miter saw bevel too?
Types of Miter Saws Turn the board on its edge, place it against the fence, and you’ll cut a “bevel.” Most saws cut from 90 to 45 degrees in both directions, and some saws can cut up to 55-degree angles.
What is the safety margin on a miter saw?
a 6”
Always maintain a 6” margin of safety between all body parts and the blade. Remove chips, scraps and cutoffs only after the blade is at a complete stop.
What is the proper attire when using the miter saw?
Wear safety glasses or goggles, or a face shield (with safety glasses or goggles). If work is dusty, use a dust extraction system, and/or respirator or dust mask. Wear appropriate hearing protection. Wear protective footwear when required.
What is the length of your cut limited to when using a miter saw?
A saw with a 10-inch blade makes right-angle cuts across a board 5 1/2 inches wide, sufficient for two-by-six lumber. The same 10-inch saw will cut a two-by-four at a 45-degree angle. Manufacturers also make 12-inch versions, which have a maximum cut of about 7 1/2 inches, wide enough for two-by-eights.
Should I wear gloves when using a miter saw?
Don’t wear gloves, loose clothing, jewelry, or any dangling objects when operating a miter saw. 3. All guards must be in place and operating.
What should the miter be on a power saw?
You first bisect the angle and determine that the miter should be 43 degrees. But when you set your saw at 43 degrees and cut the piece, the miter is NOWHERE near close! That’s because 43 degrees on a standard power miter saw gauge is really 47 degrees.
Which is the acute angle on a miter saw?
That means when they visualize the miter, they’ll be starting off on the right foot! A 22 1/2 degrees angle is an ACUTE angle. You can’t cut that miter on a miter saw without an acute angle jig. Miter saws didn’t always come with miter saw gauges that were set 90 degrees off from protractors.
What’s the correct miter angle for a finish carpenter?
Finish carpenters are always bisecting corner angles—which is easy to do with a protractor. A 135 degrees angle looks like this: A 135 degree angle is an OBTUSE angle. The miter for this corner is 67 1/2 degrees.
When to release the trigger on a miter saw?
After completing a cut, release the trigger switch and allow the blade to come to a complete stop, then raise the blade from the workpiece. If the moving blade stays in the cutting area after the cutting is complete, injury can result from accidental contact. 16.