Contents
What type of cut do you make with a miter gauge?
Make Square or Angled Cross-Cuts However, one common accessory that is typically included with your table saw, known as a miter gauge, can make the table saw just as useful for making cross-cuts perpendicular to the grain of the wood at various angles, from 90-degree perpendicular cuts to miters of almost any angle.
What cut does the miter gauge attachment make easier?
One of the easiest cuts to make using the miter gauge is the simple square crosscut. All you have to is set the miter gauge at 90 or 0 degrees (depends on the markings), and push the board toward the blade. You can also make other angle cuts at whatever angle you like by adjusting the miter gauge.
How do you cut accurate Mitre joints?
Miters: Use a Sharp Saw Blade If the blade cuts smoothly with very little pressure and leaves a clean, almost shiny cut with no burn marks, it’s sharp enough to cut good miters. When you check your blade or shop for a new one, look for one labeled as a “trim” or “fine crosscutting” blade.
What is the point of a sliding miter saw?
A sliding miter saw is a type of miter saw that adds rails to let the saw blade slide front to back across the wood. It gives you a much greater depth of cut than the same size miter saw without rails. Most sliding miter saws also include the ability to make a compound cut.
What does a miter gauge do?
A miter gauge is a device used for holding workpieces at a set angle while being cut on table saws, band saws or sanded on stationary disk sanders. The miter gauge slides in a slot on the worktable (known as a miter slot) on the machine being used.
Can you cut a picture frame with Mitre gauge?
It depends on your standards, not the quality of the mitre gauge. As the section on mitre joints in a few books shows, some people would never accept a mitre cut for a picture frame straight from the saw (any saw) but would always refine it. In the home workshop this is generally done using a mitre shooting board.
What kind of tool do you use to cut miters?
The miter is perhaps the most common of woodworking joints. Simple miters can be cut by hand using a miter box. It’s a quick and easy way to make picture frames, for example. A powered miter saw is often the tool of choice for cutting posts and narrow boards.
What can you do with a miter gauge?
A basic, low-cost miter gauge will allow for the cutting of angles to within a degree or so. For those making rustic furniture or a gate for the yard, that could well be close enough. However, much greater accuracy is possible. Machined stops at single-degree increments are common and several can further refine this to 0.1 degree steps.
What’s the Golden Rule for cutting miter joints?
Golden Rule #3 You must use the EXACT same process when cutting miter joints on the rails; don’t change the stop blocks, don’t change the angle of the miter gauge, don’t turn your miter saw to “the other side” to cut the opposing miter, if you can help it. Ornate molding or rounded molding may mean you have to turn the saw around however.