Contents
What would cause a Chevy Malibu to not start?
The most common causes that hinders normal starting operation of your Malibu are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.
Where is the fuse box in a 2009 Chevy Malibu?
Fuse box location It is located on the passenger side of the vehicle, on the lower portion of the instrument panel near the floor, behind the cover.
What do you do if your chevy malibu won’t start?
Correcting most no-start problems usually involves replacing the alternator, starter or battery, cleaning connections, ignition system repairs, or fuel system repairs.
Where is the fuse box in a Chevy Malibu?
Fuse Box Location It is located on the driver’s side of the instrument panel, behind the cover to the left of the steering wheel.
Is there a crank on my Chevy Malibu?
All the guages on the dash and all go off, but there’s no crank, no sound, nothing. When I turn back from start to on, all the guages, radio, etc power back on. All the electronics turn on and get good power in the on position lights, radio, windows, etc. It’s when I turn to start, I get nothing.
How can I get my Chevy Malibu to start?
When turning the key you’d see a visible spark on the negative terminal, and all power would go (like a dead battery). Adjusting the negative cable would reestablish power. After a couple tries, the car would start.
Why does my GM car say no start no crank?
How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.
Is the ground good on a Chevy Malibu?
All fuses are good. Checked wiring to ecm. Ground on X3 73 is good. Confirmed B+ power to terminal 20 red-white on X1. I have no power to terminal 19 pink on X1. I checked backprobing, and plugging into the front of the connector (wanted to double check).