Contents
When do I need to split my network into two LANs?
If there is another device on our network that needs a public ip it is also on VLAN 2 and VLAN 2 only. This is nice as sometimes there is a device 2 or 3 switches away that needs a public ip. Granted it means purchasing a switch that can do VLANs but you’ll probably have other uses for it down the road.
How to split a line into equal number of parts?
This functionality is similar to the Divide command available in previous ArcGIS releases. Click the Edit tool on the Editor toolbar and click the feature. Click the Editor menu and click Split. Click the Into Equal Parts split option and type the number of parts. Click OK.
Is there a way to split a line in ArcGIS?
The Split command on the Editor toolbar allows you to split a line into an equal number of new features. For example, you can use this Split option to break a line into pieces that are the same length. This functionality is similar to the Divide command available in previous ArcGIS releases.
How is subnetting used to simplify fault troubleshooting?
Simplification: Breaking large networks into smaller ones could simplify fault troubleshooting by isolating network problems down to their specific existence. To better understand the concept of subnetting, imagine a network with a total of 256 addresses (a Class C network).
Is there a way to have two subnets in one VLAN?
There’s not a way to have two different subnets in a single vlan without routing some way for it. You can do the /22 as you stated, or you can put a secondary ip address on the vlan interface: A vlan is a logically segmented network, so when you have an ip address on the svi, that’s the subnet that svi will support.
How do I switch from VLAN 1 to VLAN 10?
So we configure vlan 10, connect a utp-cable between vlan 10 and vlan 1 (access-ports, no cdp ena (cisco switches)) then reconfigure all clients from vlan 1 to vlan10, and finaly diable the def gateway ( int vlan 1, no ip addre , int vlan 10, ip address x.x.x.x, no shut) and everything works, and can work during I am doing my switchover.
Can a single cable connect to a VLAN trunk?
This should be possible (although highly unlikely that it would actually work) with a single cable, and configuring each port that the cable connects to as a VLAN trunk (best practices typically dictate IEEE 802.1Q for this) will be required, in addition to allowing each VLAN across the trunk.