Contents
When should I remove my riving knife?
When to Remove the Riving Knife A good example is when using a stacked dado blade to cut a dado or a rabbet. Because this type of blade does not create a through cut, a riving knife would serve no purpose. In fact, it would actually get in the way, blocking the completion of the cut.
What two purposes do guards on table saws serve?
Its purpose is to keep the kerf of the cut open or “split” to prevent the workpiece from pinching the blade, or contacting the rear, rising teeth of the blade and thereby causing the blade to throw the workpiece back at the operator. This is known as “kicking back” the workpiece or simply a “kickback”.
What’s the purpose of a riving knife?
A riving knife rides within the kerf, pivoting on the saw’s arbor in relation to blade height, to maintain an even gap between the two cut sides of the board, preventing jamming which could cause the stock to be forcefully ejected rearward toward the saw’s operator.
How high should my table saw blade be?
the blade should be raised so its peak is 1/8″ to 3/8″ higher than your workpiece. the blade should be raised so 1 full tooth is exposed above your workpiece.
Do you need to wear a blade guard?
It can also keep any small chips from flying into your eye, but you should always be wearing safety glasses. A blade guard does provide some finger protection, mostly serving as a visual reminder to keep your fingers away from the blade.
Why do so many people remove their table saw blade guards?
1) Probably the biggest reason I don’t use a blade guard is that I get better control of the wood without it in the way, especially when using the rip fence. I really like to use a push block to support a board and guide it through the blade. For me, this seems safer and gives me far better control over of my work-piece.
When do I need to remove my dado blade guard?
You may need to remove it when using dado blades, but for all other cuts, make sure it’s in place. It will dramatically reduce the chance of kickback. Never make a cut without it. What is the purpose of a blade guard?
When to use a blade guard on a miter gauge?
So really the only time when a blade guard would work for me is when making crosscuts while using a miter gauge and in general, these are the least likely types of cuts that a blade guard would provide protection…again, assuming I have all other safety procedures in place.