Contents
Where can I Find my IP address in Bash?
The ip command display information about ip address, manipulate routing, network devices, interfaces, tunnels and much more. The following ip command will show all ip address assigned to your system: You learned various bash commands to find both private and public IP addresses, netmask, default route, and other information.
How to get the IP address of a Linux system?
Bash command for showing the public IP address of Linux and Unix systems We can use the host command or dig command as follows to display the public IP address of your Linux or Unix system: host myip.opendns.com resolver1.opendns.com
How to get list of hostnames from list of IPS?
The END block goes through the hostnames in the ip array and checks to see whether it has any aliases or not. If it has, these are printed in parenthesis. Then the list of IP numbers are added to the end of the line. Thanks for contributing an answer to Unix & Linux Stack Exchange!
When to use shell command to get IP address?
These commands used to configure the kernel-resident network interfaces and display IP address such as 10.8.0.1 or 192.168.2.254. It is used at boot time to set up interfaces as necessary. After that, it is usually only needed when debugging or when system tuning is needed.
When to use the ifconfig command in Bash?
It is used at boot time to set up interfaces as necessary. After that, it is usually only needed when debugging or when system tuning is needed. If no arguments are given to ifconfig command, it displays the status of the currently active interfaces.
How to find the IP address of an eth0 network?
It shows an Ethernet IP address, Mac address, subnet mask, and other information. Type the following /sbin/ipconfig command to display IP address and releated networking information: In the above example, 192.168.1.2 is the IP address of the eth0 Ethernet interface.