Where is the Vim color settings file located?
You can control your vim color settings in your vim startup file. On older Unix systems the vi configuration file was named .exrc, and on modern systems it is named .vimrc. Either file will be located in your home directory on a Unix or Linux system.
How to show line numbers in vim / vi you linuxize?
Press the Esc key to switch to command mode. Press : (colon) and the cursor will move at the bottom left corner of the screen. Type set number or set nu and hit Enter. To disable the absolute line numbers off, run the :set nonumber or set nonu commands: You can also toggle the line numbers with :set number! or :set nu!: :set number!
What’s the default color scheme in Vim syntax highlighting?
When using vim syntax highlighting, a common complaint is that the default color scheme is a little too bold. In this article I’ll try to demonstrate how you can change the colors in vim to be a little more pleasing, or at least be more in your control.
What to do with autoindent in Vim?
Inside Vim, type “:echo $HOME” to see the value of “$HOME” for your system. set autoindent: New lines inherit the indentation of previous lines. set expandtab: Convert tabs to spaces. set filetype indent on: Enable indentation rules that are file-type specific.
Can you use the CTERM key in Vim?
When using a key like cterm, you can use these values: To be clear, don’t try to use color values with the cterm key — you’ll just get an error message. As shown above, you can use color values with the ctermfg and ctermg keys.
How to use convential RGB syntax in gvim?
If you’re using gvim you should visit that page for more information. It looks like you can use the convential RGB syntax (like “#FFCC99”) to specify colors in a GUI environment. Whew, that seems like a lot of “vi and vim color” ground to cover in a short time — I hope it all makes sense.