Contents
Where to place high voltage components on a PCB?
We can also apply good PCB design principles by isolating high voltage circuits from low-voltage circuits. Fabricators often recommend placing the high voltage components on the top side of a multilayer board and the low voltage circuits on the bottom side of the PCB.
Who are the high voltage PCB design experts?
Venture high voltage PCB design team has the industry leading design engineers and 10 years’ high voltage PCB design experiences. From design and material selection to circuit fabrication and final component assembly, Venture high voltage PCB design engineers have full experience in processing a wide variety of printed circuit board materials.
How to design a high voltage circuit board?
We strictly follow the high voltage PCB design standards: isolate high voltage areas and noise sources to the rest of the board, let you step the voltage down gradually and minimize interconnections, so to decrease the risk of electric arcing on the board.
What’s the difference between low voltage and high voltage PCB?
There’s a good primer here on medium-voltage and high-voltage PCB design (though your application is well into the low-voltage range, so it’s not directly applicable). You can obviously forget about corona, for example.
What makes a low voltage power supply tick?
In electronics design, getting the low voltage power supply right is what makes the circuit ticks. In PCB design, low voltage power supply refers to the power circuitry that generates the required voltage for the components. This often included voltage nodes of 5V, 3.3V or 1.8V that power the underlying circuitry.
What are the rules for high voltage circuit design?
PCB design rules must follow manufacturer guidelines for not exceeding values that can destroy the devices. For example, high voltage circuits may require components that have higher breakdown voltage ratings and the capability to handle higher currents.
What kind of devices are used in high voltage circuits?
High-voltage semiconductor devices used for motor control circuits and power supplies include MOSFETs, Insulated Gate Bipolar Transistors, MOS-controlled Thyristors, Power FETs, and Silicon-Controlled Rectifiers. PCB design rules must follow manufacturer guidelines for not exceeding values that can destroy the devices.