Contents
Which command will configure an IPv6 default static route?
DETAILED STEPS
| Command or Action | Purpose | |
|---|---|---|
| Step 2 | configure terminal Example: Device# configure terminal | Enters global configuration mode. |
| Step 3 | ipv6 route static resolve default Example: Device(config)# ipv6 route static resolve default | Allows a recursive IPv6 static route to resolve using the default IPv6 static route. |
How do I configure IPv6 routing?
To configure IPv6 on a Cisco routers, you need to do two things:
- enable IPv6 routing on a Cisco router using the ipv6 unicast-routing global configuration command.
- configure the IPv6 global unicast address on an interface using the ipv6 address address/prefix-length [eui-64] command.
How do I change the default route in Windows?
Workaround 1: Manually add the default route for the Interface
- Click Start, click Run, type cmd in the Open box, and then click OK.
- Type route print, and then press ENTER to view the routing table.
- Type the following command, and then press ENTER route add 0.0.0.0 mask 0.0.0.0 gateway IP metric 30 if Interface number.
What are four benefits of IPv6 over IPv4?
Key benefits to IPv6 include:
- No more NAT (Network Address Translation)
- Auto-configuration.
- No more private address collisions.
- Better multicast routing.
- Simpler header format.
- Simplified, more efficient routing.
- True quality of service (QoS), also called “flow labeling”
- Built-in authentication and privacy support.
What are types of IPv6 static routes?
Types of IPv6 Static and Default Routes. There are three types of IPv6 static and default routes: Directly Connected IPv6 Static Route – A directly connected static route is enabled when an outgoing interface is specified. A directly connected static route is normally used with a point-to-point serial interface.
What is a static default route?
A static default route is used to send everything that you don’t have a destination for in the routing table (depending on ip classless of course). For instance when you connect to the internet from home, your router doesn’t have a destination network for every site on the internet.
What is IPv6 config?
IPv6 Settings is one of the tabs: The IPv6 configuration allows you to enable and configure IPv6 for a WAN device. These settings should be configured in combination with the IPv6 LAN settings (go to Network Settings → WiFi / Local Networks, select the LAN under Local IP Networks, and click Edit) to achieve the desired result.