Which command would you use to see which switch interface is associated with a particular MAC address?
You can view MAC addresses assigned to interfaces using the show interfaces command.
How do I find the interface MAC address in Juniper switch?
show interfaces mac-database
- Syntax. content_copy zoom_out_map.
- Description. (M Series, T Series, MX Series routers, and PTX Series Packet Transport Routers only) Display media access control (MAC) address information for the specified interface.
- Options. ge- fpc / pic / port.
- Additional Information.
- Required Privilege Level.
How do I find my juniper MAC address?
To find the MAC 08: 62: 66: c7: b3: 45 on the Juniper switch, run the following command:
- show ethernet-switching table | match08:62:66:c7:b3:45.
- vlan151 08:62:66:c7:b3:45 D – xe-0/0/23.0.
- show interfaces xe-0/0/23 descriptions.
- Interface Admin Link Description xe-0/0/23 up up SW>DS1.
How does Junos OS support static neighbor cache?
The Junos OS supports the IPv6 static neighbor discovery cache entries, similar to the static ARP entries in IPv4. Restricted and Unrestricted Proxy ARP Overview By default, the Junos OS responds to an Address Resolution Protocol (ARP) request only if the destination address of the ARP request is local to the incoming interface.
How to show MAC address, IP and interface in ex Switch?
Is there any commands that we can use to show something like show arp that will display mac address, ip address and interface in one table. I have 4 access switches, 1 core switches, and 1 srx firewall, while i run show arp in srx, yes there lot of output, but when run the same command on core switch or access switch nothing display.
How to show the MAC address table interface?
07-20-2020 01:21 PM When I run this specific command exactly as you have typed it Giuseppe, I get the MAC associated with every port in the stack. The switches I am running this on are chassis, so if the supervisory module is included then I get every MAC the switch can see!
Can a Junos OS respond to an ARP request?
The Junos OS supports the IPv6 static neighbor discovery cache entries, similar to the static ARP entries in IPv4. By default, the Junos OS responds to an Address Resolution Protocol (ARP) request only if the destination address of the ARP request is local to the incoming interface.