Which network protocol is used to route?
Explanation: Internet protocol is used to route the IP addresses. Internet Protocol (IP) assigns the unique address to the system which is known as IP address that is involved in the network. These IP addresses routes the packets of data from the source system to the destination system.
Which protocol supports load balancing?
A: An Application Load Balancer supports load balancing of applications using HTTP and HTTPS (Secure HTTP) protocols.
How are routing paths determined?
To determine the best path, the router searches its routing table for a network address that matches the destination IP address of the packet. This means that the destination IP address of the packet is a host address on the same network as the interface of the router.
What is the purpose of IP routing?
IP Routing is an umbrella term for the set of protocols that determine the path that data follows in order to travel across multiple networks from its source to its destination. Data is routed from its source to its destination through a series of routers, and across multiple networks.
How are routing protocols used in the network?
Routing protocols are used to distribute routing information between routing devices. This information will change over time based on network conditions; therefore this information is critical to ensure that packets will get to their destinations. Of course, attackers can also use routing protocols for attacks.
What’s the difference between classful and classless routing protocols?
Classful Routing Protocols (3.1.4.5) The biggest distinction between classful and classless routing protocols is that classful routing protocols do not send subnet mask information in their routing updates. Classless routing protocols include subnet mask information in the routing updates.
What makes an IPv6 routing protocol classless?
Classless routing protocols support VLSM and CIDR. IPv6 routing protocols are classless. The distinction whether a routing protocol is classful or classless typically only applies to IPv4 routing protocols. All IPv6 routing protocols are considered classless because they include the prefix-length with the IPv6 address.
When does a link state routing protocol update?
Link-state routing protocols do not use periodic updates. After the network has converged, a link-state update is only sent when there is a change in the topology. For example, in Figure 3-12, the link-state update is sent when the 172.16.3.0 network goes down.