Why are some of the hop IPS the same even though the destinations are different?

Why are some of the hop IPS the same even though the destinations are different?

The reason for that result on a trace is that, some ISP, does load balance in his Autonomus System, thats it: same destination across diferent ways. This is the reason that you looks, in the same hop, ex: 4, 5 and 6, that one packet goes hrough every one of the links that can reach the destination.

How do you find the number of hops between the source and destination?

Traceroute depends on TTL to measure the distance between source and destination and to find the hops in between. In a traceroute, the source re-defines the TTL value every time it gets a response and sends the packet with TTL= +1 until it reaches its destination.

What is a hop in a trace route?

The journey from one computer to another is known as a hop. The amount of time it takes to make a hop is measured in milliseconds. The information that travels along the traceroute is known as a packet.

What is TTL in Ping?

The TTL field, Time To Live, of an IP packet represents the maximum number of IP routers that the packet can go through before being discarded. During normal operation, ping prints the TTL value for every packet it receives.

How can you track an IP address?

How to Trace an IP Address Using the Command Prompt

1. Open the Command Prompt. First, press the Windows key and the “R” button.
2. Ping the Website You Want to Trace. Type “ping” followed by the URL of the website to get its IP.
3. Run the “Tracert” Command on the IP.
4. Put These IPs Into an IP Lookup Tool.

How do I find the source and destination IP address in Windows?

To use tracert, you must be running Microsoft Windows.

1. Open a Command Prompt.
2. In the Command Prompt window, type ‘tracert’ followed by the destination, either an IP Address or a Domain Name, and press Enter.
3. The command will return output indicating the hops discovered and time (in milliseconds) for each hop.

Which command used to show the path of network?

Traceroute – The traceroute command is used to determine the path between two connections. Often a connection to another device will have to go through multiple routers. The traceroute command will return the names or IP addresses of all the routers between two devices.

Can a traceroute show the same hop twice?

Traceroute and all data packets are flowing but fear this double hop is an issue waiting to happen. ! ! ! ! ! ! ! Show ip route on the border router shows the border router is layer two adjacent to the last hop 10.10.50.5 via BVI20.

Which is the last IP in trace route?

The destination IP in your case is 114.0.36.130, and this is the last hop. On different runs of traceroute to a destination, you can certainly see different paths to that destination. And, the following behavior is common – multiple routers replying to the same probe TTL packet.

Why is the result same hop but different destination IP?

From the result, I found there is some hop is same but destination ip is different. Could you help me to know about this issue? The reason for that result on a trace is that, some ISP, does load balance in his Autonomus System, thats it: same destination across diferent ways.

How does tracert determine the route to the destination?

The TRACERT diagnostic utility determines the route to a destination by sending Internet Control Message Protocol (ICMP) echo packets to the destination. In these packets, TRACERT uses varying IP Time-To-Live (TTL) values.