Contents
Why did Intel create an 8087 to be a coprocessor of 8086?
The Intel 8087, announced in 1980, was the first x87 floating-point coprocessor for the 8086 line of microprocessors. The purpose of the 8087 was to speed up computations for floating-point arithmetic, such as addition, subtraction, multiplication, division, and square root.
Which pin belongs to the 8087 coprocessor?
�BUSY signal 8087 is connected to TEST pin of 8086. �Interrupt output INT of the 8087 to NMI input of 8086. This intimates an error condition.
How many general purpose registers are there in 8086?
seven general purpose registers
Aside from the four segment registers introduced in the previous section, the 8086 has seven general purpose registers, and two status registers. The general purpose registers are divided into two categories. Four registers, AX, BX, CX, and DX, are classified as data registers.
What is numeric coprocessor?
A mathematical circuit that performs high-speed floating point operations. Also called a “floating point unit” (FPU), the math coprocessor may be a stand-alone chip or circuits built into the CPU.
Which is not valid instruction?
Which of the following instruction is not valid? Explanation: Both the source and destination operands cannot be memory locations except for string instructions.
Is the 8086 the host or the coprocessor?
This interface is also called as coprocessor configuration. Here 8086 is called as the host and 8087 as coprocessor as it cannot operate all by itself. We write a homogeneous program which contains both 8086 as well as 8087 instructions.
When did the Intel 8087 coprocessor come out?
Intel 8087. The Intel 8087, announced in 1980, was the first x87 floating-point coprocessor for the 8086 line of microprocessors.
How is the 8086 and 8088 connected to the CPU?
The 8086 and 8088 have two queue status signals connected to the coprocessor to allow it to synchronize with the CPU’s internal timing of execution of instructions from its prefetch queue. The 8087 maintains its own identical prefetch queue, from which it reads the coprocessor opcodes that it actually executes.
How are the instructions written to the 8087?
Instructions for 8087 are written in the program as needed, interspersed with 8086 instructions. As the 8086 fetches instruction bytes from the memory and puts them in its queue, the 8087 also reads these instruction bytes and puts them in its queue.