Contents
Why do fans always start on the highest setting?
As others have stated, the higher jolt of electricity on high gets the fan going, but it also uses the higher momentum. When started on high and switched to low, the blades will be spinning at a slightly higher rate than if they started on low, and will consume slightly less electricity.
How do you troubleshoot a bad fan?
Floor Fan Stopped Working? Your Troubleshooting Guide
- Check the Cord. It sounds simple, but your first step should be to make sure the cord is securely plugged in.
- Check Your Circuit Breaker.
- Check for Power to Your Outlet.
- Check the Fan Fuse.
- Replace the Cord.
- Clean the Fan.
- Grease the Motor.
- Call Customer Support.
How do you fix a Lasko fan that stopped working?
Try unplugging the fan for at least 15 minutes, and then plug in the fan again. When you do this, make sure the fan is OFF while it is resting. Also, make sure you turn the fan to ON after plugging it back in.
How do you reverse a fan rotation?
Using a ladder or step stool to reach the motor housing, locate the direction switch. Flip the switch in the opposite direction. Step down and turn the ceiling fan back on. Verify the ceiling fan blades are moving in the right direction.
Why does my fan not run when I Turn on the thermostat?
This problem can happen in both heating and cooling mode. Rule out bad fan motor or no power to fan. First, by noting that the fan will run when you set the thermostat to FAN ON we know that the fan has power and the fan motor starts and runs just fine. So the problem is elsewhere.
What to do if your fan is not set to auto?
If your fan was set to run continuously at either the thermostat or at the limit switch you’ll need to turn that feature off. Be sure the fan is set to AUTO: We’ll continue with the fan NOT set to run continuously.
How can I tell if my electric fan is still working?
If you don’t hear anything, put your ear up to the middle of the case behind the blades. Press the button to turn the fan off and on again, this time listening closely for the motor. If you hear it humming or buzzing, your motor is likely still functioning. Check the fan in multiple outlets.
What causes a fan to get stuck in a wheel?
The blower wheel (attached to the fan motor) may also be clogged with dirt or debri, as shown below. Sometimes, even a dead animal; such as a squirrel have been found stuck in a blower wheel! Never attempt to work on the motor or blower wheel unless the power has been turned off to the unit. Most fans are energized by a fan relay.