Contents
Why does my Ender 3 have extrusion issues?
This allows the filament to move around slightly in the tube which causes stringing issues as well as other extrusion issues. Luckily, there is an easy fix. Capricorn PTFE Bowden tubes are well known in the 3D printing community for their value and precision.
Is the Ender 3 3D printer a picture perfect machine?
However, that does not mean that it has no faults or it is a picture-perfect machine for 3D printing purposes. All filament printers have certain issues that need must be addressed if they are to work at their prime, day in day out. Let’s look at a common issue that plagues the Ender 3: under extrusion, and talk about fixes.
How to fix the nozzle on an Ender 3 printer?
Clean and Adjust the Nozzle 1 Cleaning With the help of a Needle. In case the nozzle of your Ender 3 3D printer is clogged, you should consider pushing the material through the tip with the 2 The Cold Pull/Atomic Pull Technique. 3 Check Z Distance. 4 Replace the PTFE Tube. 5 Fix the Hot End of the Printer.
Why is the Bowden on my Ender 3 not working?
The stock bowden tube that comes on the Ender 3 has a inner diameter that is a little too big. This allows the filament to move around slightly in the tube which causes stringing issues as well as other extrusion issues. Luckily, there is an easy fix.
Why is the Bowden tube on my Ender 3 too big?
If you already have Capricorn tubing, you can skip below to the Tuning ESteps section. The stock bowden tube that comes on the Ender 3 has a inner diameter that is a little too big. This allows the filament to move around slightly in the tube which causes stringing issues as well as other extrusion issues. Luckily, there is an easy fix.
Is the SKR mini E3 v1.2 serial?
Correct because the SKR Mini E3 V1.2 uses software serial. Related to that: you’ll see slave addresses have been added to the SKR Mini E3 V2.0 since BigTreeTech went back to using hardware serial. Hi @thisiskeithb, I noticed that the change for the slave address is available for the v1.0, not need on the v1.2?
Is the stepper motor on my Ender 3 getting hot?
Sign in to your account Stepper motors on my Ender 3 are getting very hot using Skr mini E3 board. I am using the default firmware which was provided. I am wondering which parameters I should tune in configuration_adv.h for tmc2209?