Contents
Why is LaTeX putting my figures at the end?
Your figures are most likely too large and/or you tell LaTeX to place them at a position where they don’t fit. So they are are pushed to the last position were they finally do: the end of the document.
How do I force a figure to the top of a page in LaTeX?
You can insert a pagebreak via \clearpage or \newpage , then use the t option on the figure environment: \clearpage \begin{figure}[t!]
How do I put text over a picture in LaTeX?
\\ \begin{figure}[ht] \centering \includegraphics[scale=0.75]{picture. jpg} \caption{The caption} \label{fig:picture} \end{figure} Some more text… Latex insists on putting everything but a new section above the image even though its below the image in the code.
How do you stop a floating figure in LaTeX?
placeins provides the command \FloatBarrier to limit the floating of figures or tables. You could place such a barrier before and after a listing. afterpage allows a more clever \clearpage , putting the effect off until the page is full: \afterpage{\clearpage}
How do you insert a picture on top of LaTeX?
Including images in your LaTeX document requires adding: sepackage{graphicx} to the beginning/preamble of your document. \includegraphics{ } command tells LaTeX to insert the image. To upload an image, click the upload button, and upload your image file.
How do I get my images to stay where I put them in LaTeX?
In general text you can force a LaTeX image to stay where it is placed in the code using the [! h] command in the figure environment. A slight modification of this which allows the image to move to the top of the next page if there is an overhang is the [! ht] command.
How do I make sure a figure stays in LaTeX?
Usually with \begin{figure} or \begin{table} i.e. floats, the default placement identifier is [btp] , which means LaTeX is allowed to place the figure at the b ottom of the page/column; t op of the page/column; or if the float is quite tall (including the caption), all on its own on a float p age without any text.