Contents
Why is my tail light and brake light not working?
The electrical ground is one of the things you should also check if the taillights are working and brake lights are not. This could be the possible issue, especially when the brake light switch is functional. Check for bad electrical ground which may be a result of corroded or damaged wires.
Where is the rear brake light fuse?
If the fuse fails, electricity can’t reach the lights, which may be in fine working order otherwise. Like all fuses, the brake light system fuse can be found in the power distribution center, which is under the dashboard or tucked away underneath the hood.
Can you drive with a brake light out?
If your vehicle has something wrong with it, for example a broken brake light, the police may give you a ‘vehicle defect rectification notice’. You’ll need to get your vehicle fixed and provide proof that it’s been fixed, for example a receipt for the work from a mechanic.
Why is only one of my tail lights working?
If only one of the tail lights appears to be out, the mechanic should check to see if the unlit bulb is burned out. Over time, bulbs will eventually fail and need to be replaced. The mechanic will check the filament in the unlit bulb to see if it is broken. If so, he or she will replace the bad bulb with a new one.
Do all 3 brake lights have to work?
Federal law mandates that all vehicles have the third brake light outfitted within the car. Additionally, the third light must be comparable to the other brake lights on the vehicle so that it is not distracting to the drivers behind the vehicle.
How can you tell if a brake light socket is bad?
The socket may have gone bad Push the point of the tester through the wire insulation behind the socket to make contact with the wire. The tester should light for two of the three wires (the ground wire won’t light). If it lights for two wires, the wiring is good. Simply replace the socket.
Is it illegal to drive with a brake light out?
Why are the brake lights on my Zafira not working?
For the first few pressing of the brake pedal all is ok, then the brake lights stop working & he gets a dashboard fault display. The LED light in the tailgate carries on working okay. If he turns the Ign off then back on, he gets another few OK operations of the brake lights.
Why are the brake lights on both sides not working?
Even tried pulling battery lead for a bit. Any ideas folks as only specific lights on both sides. So which lights aren’t working, are the side light brake light on the same bulb as in double filament, or are they separate, if you press the brake does the side light come on.
Is the high level brake light still working?
Everything electrical works perfectly except yesterday I noticed the main brake lights had stopped working, bulbs are fine, all connections I can check easily are good and the high level brake light works?
Is the brake light on the tailgate working?
The LED light in the tailgate carries on working okay. If he turns the Ign off then back on, he gets another few OK operations of the brake lights. The foot pedal switch, & the bulbs have been changed. I read that there may be a REC unit on the car ?