Contents
Why use LACP rate fast?
The LACP rate fast feature is used to set the rate (once every second) at which the LACP control packets are sent to an LACP-supported interface. The normal rate at which LACP packets are sent is 30 seconds.
What is LACP fast rate?
1 per second
LACP Rate Fast is a command that allows partners to send LACP PDUs at a rate of 1 per second even after synchronization. By setting a bit or flag in the LACP PDU, which is known as the LACP Timeout bit.
What is LACP rate?
LACP Rate. Specifies how fast the bonded interfaces should transmit LACPDU packets. The default is every 30 seconds, characterized by the lacp_rate value of “0” or “slow”, or every second, characterized by the lacp_rate value of “1” or “fast”.
What is Lacp fast switchover?
Lacp rate fast is used to set the rate at which Link Aggregation Control Protocol (LACP) control packets are ingressed to an LACP-supported interface. The following command is used to modify the duration of a LACP timeout. The LACP timeout value is set on Cisco switches to a value of 90 seconds.
What is LACP port priority?
The LACP Port-priority determines the ports that are placed in standby mode when hardware limitations prevent a single aggregation of all compatible ports.
What is LACP timeout?
The timeout value is the amount of time that a port-channel interface waits for LACP data units from the remote system before terminating the LACP session.
When to use the LACP rate fast command?
Lacp rate fast is used to set the rate at which Link Aggregation Control Protocol (LACP) control packets are ingressed to an LACP-supported interface The following command is used to modify the duration of a LACP timeout. The LACP timeout value is set on Cisco switches to a value of 90 seconds.
How to set the LACP rate on a Cisco Nexus 5000?
You can configure the LACP rate fast feature on the LACP ports of a Cisco Nexus 5000 Series switch or a Cisco Nexus 2000 Series Fabric Extender that is connected to a Cisco Nexus 5000 Series switch. The LACP rate fast feature is used to set the rate (once every second) at which the LACP control packets are sent to an LACP-supported interface.
How long is the LACP timeout on a Cisco switch?
The following command is used to modify the duration of a LACP timeout. The LACP timeout value is set on Cisco switches to a value of 90 seconds. Using the lacp rate command, you can select the LACP timeout value for a switch to be either 30 seconds or 1 second.
How often does the 3750 support slow LACP?
The 3750 only supports slow LACP. The rate for this is every 30 seconds. The 6500 series will support a “Fast” or 1 second LACP rate. 07-17-2017 10:43 PM