Which of the following characteristics should match for a link to be bundled into an EtherChannel choose two?

Which of the following characteristics should match for a link to be bundled into an EtherChannel choose two?

Explanation: For an EtherChannel to be created, the ports that are concerned on the two switches must match in terms of the speed, duplex, and VLAN information.

Is LACP redundant?

LACP aggregates multiple physical links between the same two devices into one logical link that has higher throughput. If you are looking for redundancy in case of a switch failure, then you need to set up links to two switches, and configure the server to bridge the two links with the spanning tree protocol enabled.

What are the requirements of EtherChannel?

Prerequisites of Enabling EtherChannel

• EtherChannel bundle links must be of the same type and speed.
• All links intended to be bundled MUST NOT exceed the number of eight physical links.
• All links MUST belong to the same VLAN if used as access links.

What are the two advantages of using LACP?

It allows directly connected switches to negotiate an EtherChannel link. It provides a simulated environment for testing link aggregation. It decreases the amount of configuration that is needed on a switch.

What is LACP protocol?

Link Aggregation Control Protocol or LACP is one element of an IEEE specification (802.3ad) that provides guidance on the practice of link aggregation for data connections. Importantly, LACP typically applies to strategies that bundle individual links of Ethernet connections, and not wireless transfers.

Does link aggregation increase Internet speed?

Link Aggregation increases bandwidth and throughput by aggregating multiple network interfaces and provides traffic failover to maintain the network connection in case the connection is down. The total network bandwidth will only increase if there are multiple clients.

What is the difference between LACP and EtherChannel?

EtherChannel vs. Both technologies are capable of automatically configuring this logical link. EtherChannel supports both LACP and Cisco’s PAgP, whereas 802.3ad uses LACP. LACP allows for up to 8 active and 8 standby links, whereas PAgP only allows for 8 active links.

What is LACP priority?

LACP system priority: A LACP system priority is configured on each router running LACP. The system priority can be configured automatically or through the CLI. LACP uses the system priority with the router MAC address to form the system ID and also during negotiation with other systems.

Do you need to enable LACP at both ends?

However, to initiate the transmission of link aggregation control protocol data units (PDUs) and response link aggregation control PDUs, you must enable LACP at both the local and remote ends of the links, and one end must be active: Active mode—If either the actor or partner is active, they exchange link aggregation control PDUs.

Which is the highest priority interface in LACP?

The interfaces with the highest LACP interface priority become active interfaces. LACP mode is also called M:N mode, where M refers to the number of active links and N refers to the number of backup links. This mode guarantees high reliability and allows traffic to be load balanced among M active links.

When do LACP MTUs need to be matched?

This isn’t critical for TCP services because of TCP MSS negotiation, but UDP services need matched MTUs if they send large packets. On other switch to switch / switch to router links, the data-link MTU must be at least large enough for your server MTUs + any other services added by your routers (such as IPSec, MPLS, etc…).

Why do we need LACP for aggregation control?

LACP provides a standardized means for exchanging information between partner (remote or far-end of the link) systems on a link. This exchange allows their link aggregation control instances to reach agreement on the identity of the LAG to which the link belongs, and then to move the link to that LAG.