Contents
How do I add a static route to my HP-UX?
To add routes temporarily, use the ‘route’ command. See the manpages. To add routes permanently, add them to ‘/etc/rc. config.
How do I add a static route to my HP router?
Static route FRR configuration example
- Configure IP addresses for the interfaces on each switch and configure static routes: Follow Figure 2 to configure the IP address and subnet mask of each interface on the switches.
- Configure static route FRR. # Configure Switch S:
- Verify the configuration.
How do I set static routes on my computer?
Add a Static Route to the Windows Routing Table You can use the following syntax:
- route ADD destination_network MASK subnet_mask gateway_ip metric_cost.
- route add 172.16.121.0 mask 255.255.255.0 10.231.3.1.
- route -p add 172.16.121.0 mask 255.255.255.0 10.231.3.1.
- route delete destination_network.
- route delete 172.16.121.0.
How do I change my default gateway on HP-UX?
Re: how to change the default gateway in HP-UX else as suggested earlier you can directly edit the /etc/rc. config. d/netconf, change the default route and do the do /sbin/init. d/net stop and /sbin/init.
How to count route in HP UX version 2?
Hewlett-Packard Company – 3 – HP-UX 11i Version 2: Sep 2004 route (1M) route (1M) count An integer that indicates whether the gateway is a remote host or the local host. If the route leads to a destination through a remote gateway, count should be a number greater than 0.
Who is the author of route in HP-UX?
The HP-UX implementation of route does not presently support a change subcommand. AUTHOR [Toc] [Back] route was developed by the University of California, Berkeley.
When to use TOC warnings in HP UX?
WARNINGS [Toc] [Back] Reciprocal route commands must be executed on the local host, the destination host, and all intermediate hosts if routing is to succeed in the cases of virtual circuit connections or bidirectional datagram transfers. The HP-UX implementation of route does not presently support a change subcommand.
When did HP UX version 2 come out?
Hewlett-Packard Company – 1 – HP-UX 11i Version 2: Sep 2004 route (1M) route (1M) -n Print any host and network addresses in Internet “dot” notation for IPv4 and in “colon” notation for IPv6, except for the default network address, which is printed as default . -p pmtu Specifies a path maximum transmission unit (MTU) value for a static route.